Bascom, Jackson County
Garage Door Services in Bascom, Florida
Doors on detached garages, shops and outbuildings in Bascom, and the seals that keep weather and critters out of them.
Garage doors on buildings apart from the house
Big Bend Services, Inc. repairs and replaces garage doors in Bascom, ZIP code 32423, on attached garages and on the buildings that stand on their own: detached garages, workshops, sheds and other outbuildings with an overhead door. The work includes replacing springs, repairing cables, rollers, hinges, tracks, panels and safety sensors, renewing weather seals, repairing openers or putting in new ones, and installing new doors measured to the opening. Roll-up doors are included.
Call (850) 819-6031 or send the form with the Bascom address, which building the door is on and what it is doing. We will arrange a time to see it and send a written quote.
Outbuildings
What is different about a detached garage or shop door
A door on a detached building is built the same way as one on a house, with sections, track, springs and cables, or a coiled curtain on a roll-up. The building around it is where the differences come in, and they shape what a repair or a new door involves.
Power for an opener
An opener plugs into an outlet near where it hangs. A detached building may have no power at that spot, and it has to be in place before an opener can be fitted. A door without an opener is repaired to lift easily by hand.
Low headroom
A shop or shed can have little space between the top of the opening and the roof framing. Track made for low headroom, or a wall-mounted opener beside the door, can fit where a standard setup will not.
A wide or tall opening
An opening sized for a truck, a tractor or a boat trailer takes a larger door with heavier springs. Some of these openings suit a roll-up door better than a sectional door.
An opening you have outgrown
A door can only be as big as the opening it closes. If larger equipment now has to fit through, widening or raising the opening is framing work, and that is outside our service.
Doors that are lifted by hand
A door with no opener is lifted from its handle and held shut by a lock or a slide bolt. When the springs are right, it lifts with light, steady pressure and stays at whatever height you leave it. A slide bolt has to stay open on a door that an opener runs, since the opener cannot lift a bolted door. A door that has turned heavy, drops when let go or springs up on its own is out of balance, and the springs and cables are set right or replaced.
Weather seals
Seals around a Bascom garage door
A garage door is closed off by three sets of seals. When any of them wears out, you see daylight at the gap, and rain, leaves, dust, insects and small animals can find their way inside.
Bottom seal
A rubber or vinyl strip held in a channel along the bottom of the door. It squashes against the floor when the door closes. Once it is torn, flattened or stiff, it leaves a gap, and a new strip is fitted.
Side and top seals
Flexible strips fastened to the frame on both sides and across the top. The door presses against them when it closes. Worn, cracked or loose strips are replaced along the full height and width of the opening.
Gaps at the bottom corners
The bottom seal and the side seal meet at each bottom corner, and a torn end on either leaves a gap there. New seals are fitted so they meet and close it.
Seals on a roll-up door
A roll-up door seals along its bottom bar and inside its side guides. Worn seals in either place are replaced.
Gaps that seals cannot close
A door that closes crooked, or a slab that dips at one side, can leave a gap no seal will fill. The door is set level first, then the seal is fitted to what is left.
New doors for detached garages and shops
When the door on an outbuilding is past repair, we measure the opening and quote a new door to fit it: width, height, the headroom above and the room on each side for track. A new opener can go on the same quote, or the door can be quoted to run by hand. A door that is not run by an opener has no safety sensors, since sensors work only through an opener.
Repairs
Repairs on any Bascom garage door
Springs
A broken spring is replaced. Until it is, the door is heavy and should stay where it is.
Cables and rollers
Frayed cables and rollers that grind, stick or have jumped the track are replaced.
Hinges and track
Cracked hinges and bent or loose track sections are replaced so the door runs straight.
Panels
A dented or cracked section is replaced when a match is still made, or the door is quoted for replacement.
Safety sensors and openers
Sensors that stop the door closing are lined up or replaced, and an opener that has failed is repaired or replaced.
Booking work in Bascom
Calls are taken at our Wewahitchka office, Monday to Friday, 7:00 AM to 4:00 PM. If there is more than one door on the property, say which ones need work. For an outbuilding, let us know whether the door has an opener, whether it is a sectional or a roll-up, and roughly how wide and tall the opening is. For a seal job, tell us where you see light or water getting in, and whether it is along the bottom, the sides or the top. If the building is kept locked or sits behind a gate, tell us who will open it on the day.
Same county
Garage door services in nearby Jackson County towns
What to expect
How a Bascom door job comes together
- 1
Contact
Call (850) 819-6031 or send the form. Tell us the town and what needs work.
- 2
Property visit
We come out, look at the job and take the measurements we need.
- 3
Written quote
You get a written price for the work before anything starts.
- 4
Work completed
We do the work, test it and clean up the work area.
Can an opener be added to a door that has always been run by hand?
Water gets in under the door in hard rain. Will a new bottom seal stop it?
Can a roll-up door go on a shed or barn?
Do the seals between the sections wear out too?
Is there anything else you can do on an outbuilding?
Get a quote
Request Garage Door Repair in Bascom
Tell us which building the Bascom door is on and what it is doing, and the office will reply to arrange a time.
