Grand Ridge, Jackson County
Closet and Wire Shelving in Grand Ridge, Florida
Reach-in closets set for what hangs and what sits, and new shelving where the old has sagged, for Grand Ridge homes.
Reach-in closet shelving in Grand Ridge
Big Bend Services, Inc. supplies and installs wire shelving at Grand Ridge addresses in ZIP code 32442. A reach-in, the bedroom or hall closet with a door on the front, comes down to a shelf, a rod and the space around them. Closet shelving that has sagged or come away from the wall can be replaced too, and walk-ins, pantries, laundry rooms, garages and storage rooms are part of the same service.
Reach the office on weekdays, 7:00 AM to 4:00 PM, at (850) 819-6031, or send the form. Our office is in Wewahitchka. Each job gets a written quote with one price.
Setting the rod by what hangs on it
Start with the clothes. For a single rod, the rod goes about 66 inches off the floor, which clears long dresses and coats. For double hang, the upper rod goes near 80 inches and the lower one near 40, and each row of shirts, blouses and folded pants hangs clear of the one below.
A closet for a young child can start with the rod much lower, near 45 inches, so the child can hang and take down their own clothes. On adjustable shelf-and-rail, that rod moves up in steps as they grow.
Layouts
Reach-in closet layouts for bedrooms
The width of the closet and what you own pick the layout.
Double hang across the width
Two rows of short hanging clothes, for a closet with mostly shirts and pants.
Split hang
Long hang at one end for dresses and coats, double hang along the rest.
A shelf column
A narrow stack of shelves at one end for folded sweaters, jeans and shoes, with hanging beside it.
A second top shelf
In a closet with a tall ceiling, a higher shelf holds out-of-season clothes and spare blankets.
Doors, depth and the ends of the closet
The door shapes the layout. With a bypass sliding door, only half the closet is open at a time, so it helps to put hanging behind one panel and the shelf column behind the other. With bifold doors, the folded panels sit inside the opening and the shelf ends have to clear them.
The ends of a reach-in, behind the wall on each side of the opening, are hard to see and reach, and a shelf that runs into them is the place for things needed a few times a year. A closet too shallow for hangers to hang square is better used for shelves than for a rod.
Other reach-ins
Hall, coat and guest room closets
Coat closet
A rod set for long coats and rain jackets, a top shelf for hats and gloves, and floor space for boots and an umbrella stand.
Guest room closet
Mostly open rod with a few empty hangers, plus a shelf for spare bedding and a folded luggage rack.
Hall closet as storage
Shelves top to bottom for games, a vacuum and cleaning supplies, with the rod left out.
Closet in a home office
Shelves spaced for paper, binders and a printer, with an outlet left clear.
A hall linen closet
Shelves top to bottom with gaps sized to folded towels and sheets.
In the way
Closets with something on the wall or ceiling
An attic hatch
The shelf stops short of the hatch, so the opening can still be reached from a ladder.
An air return or vent
The vent face stays clear, and shelving starts beside it rather than in front of it.
A light switch inside the closet
The nearest shelf ends before the switch plate, so the switch stays easy to reach.
A sloped ceiling
Each shelf is cut to fit its height, so the low end of the closet is still used.
Why wire
What wire shelving does in a closet
Air moves through
Open wire lets air circulate around folded clothes on the top shelf.
Light reaches the rod
The closet light shines through the shelf onto the hanging clothes below.
Sagging shelves
Replacing a closet shelf that sags or has pulled loose
When a rod bows under a winter of coats or a shelf lip tips forward, clothes slide to the middle and the shelf above them dips.
Support where the weight is
A packed rod or a stack of jeans gets a shorter span between supports than a shelf of hats.
Same layout or a better one
The new run can match what was there, or add a second rod or a shelf column while the closet is empty.
Rod and shelf as a set
When the rod came down with the shelf, both are replaced together.
Other rooms
Other rooms in the house
Walk-in closets
The same rod heights spread across several walls, with a shelf wall for shoes and an aisle kept open down the middle.
Pantries
Levels spaced for cans, boxes and small appliances, with the floor left for cases of drinks.
Laundry rooms
A shelf high enough over the washer for the lid to open, with a rail for shirts from the dryer.
Garages
Shelving kept below the door tracks and clear of the opener.
Your request
What to tell us about Grand Ridge closets
The closets
How many, and what kind of door each has.
Who uses them
An adult, a child or guests.
A sagged shelf
Which closet, and what the shelf was carrying.
Same county
Wire shelving in nearby towns
What to expect
How a reach-in closet job runs
- 1
Contact
Call (850) 819-6031 or send the form. Tell us the town and what needs work.
- 2
Property visit
We come out, look at the job and take the measurements we need.
- 3
Written quote
You get a written price for the work before anything starts.
- 4
Work completed
We do the work, test it and clean up the work area.
How much space goes between the shelf and the rod?
Can a small dresser fit in a reach-in closet?
Our closet has a light fixture just above the shelf. Does that change anything?
Besides closets, what work do you take on?
Do you shelve for builders and businesses?
Get a quote
Request Wire Shelving Installation in Grand Ridge
Send the address and the closets you want shelved, and the office will follow up to arrange a time.
