Alford, Jackson County
Garage and Wire Shelving in Alford, Florida
Garage wall shelving that leaves the door, tracks and opener their room, and shelving for new houses, in Alford.
Garage wall shelving in Alford
Big Bend Services, Inc. supplies and installs wire shelving at Alford addresses in ZIP code 32420. A garage wall has to leave room for the door as it opens, for the opener and for the car. Closets, pantries, laundry rooms, and utility and storage rooms are shelved as well, and commercial customers are served.
Phone (850) 819-6031 on weekdays, 7:00 AM to 4:00 PM, or send the form. Our office is in Wewahitchka. You get a written quote with one price for the job.
Three zones
Where shelving can go in a garage
The door end
The front wall on either side of the opening holds the vertical tracks and, above them, the springs and the raised door. That wall stays bare.
The side walls
The horizontal tracks run along the ceiling near these walls. Shelving fits underneath, with the top shelf far enough below the track that a box lifts off.
The back wall
The opener hangs from the ceiling near here, so shelves on this wall stop below it and leave the release cord within reach.
Things on the walls
The electrical panel, a water heater, an attic ladder, a side door and any outlet you use stay clear.
Sizing garage shelves around the car and the gear
Shelf depth matters most beside a parked car. A deep shelf eats into the space needed to open the car door and step out, so the wall next to the driver side takes a shallower shelf than a wall nobody parks against. The back wall, in front of the hood, has room for deeper storage bins.
Height is set by what goes underneath. If a mower, a trash can or a bicycle lives against the wall, the lowest shelf goes above it.
Awkward things
Garage things that need their own spot
Rakes, shovels and brooms
A floor-to-shelf gap at the end of a run gives long-handled tools a place to stand upright in a bin or barrel.
A chest freezer
Shelving above a freezer stays high enough for the lid to open all the way and for you to reach in.
Coolers and camp chairs
Bulky but light, so they go on a deep top shelf rather than taking a low one.
Ladders and folding tables
A section of wall with no shelving lets tall, flat things lean upright without blocking a run.
Rear hatches, tailgates and the back wall
A car or SUV that backs into the garage swings its rear hatch or tailgate up and out toward the back wall. Shelving on that wall has to sit below the height the hatch reaches when open, or stop far enough from where the car parks that the hatch clears it.
Shops
Garage shelving for a shop or small business
Parts and supplies
Shallow shelves at eye level for small bins, so every label is in sight.
Stock by the box
Deep, low shelves near the big door, where deliveries come in.
A cart path
An aisle kept wide enough to roll a cart or hand truck between runs.
When the washer and dryer are in the garage
If the laundry is in the garage, its shelving and the garage shelving are planned as one wall. The shelf over the machines clears a top-loading lid, the water valves and dryer vent stay reachable, and a hanging rail can run beside the dryer. The rest of that wall carries garage storage, kept apart from the laundry shelf so detergent and paint cans do not end up side by side.
For builders
Shelving for new houses before move-in
Builders are served, and a new house is the easiest time to put shelving in: the rooms are empty and nothing has to be moved out of the way.
The garage
The back wall can be shelved before move-in, or left bare for the owner to plan around their own cars and gear.
What to send
The address, the rooms that get shelving, and the date the house will be ready for it.
A starting layout for a new house
A builder does not know what the buyer owns, so the shelving has to suit whoever moves in. One layout: reach-in bedroom closets with a shelf over a single rod, a walk-in with one long-hang section and the rest double hang, a pantry with evenly spaced levels from knee height up, and a laundry shelf over the machines with a hanging rail. Adjustable shelf-and-rail in the pantry lets the buyer move shelves to suit their groceries.
Other spaces
Utility rooms and storage rooms
Utility rooms
Shelves beside the water heater and air handler, with the controls, the filter slot and the electrical panel left reachable.
Storage rooms
Deep shelves for totes and boxes, and shallow ones for paint and small tools that get lost at the back.
Your request
Before you call about an Alford garage
Cars
How many park inside, and on which side.
Open walls
Which walls are clear for shelving and what you plan to store on them.
Appliances
Whether the garage also holds the washer and dryer or a freezer.
Same county
Wire shelving in nearby towns
What to expect
How a garage shelving job runs
- 1
Contact
Call (850) 819-6031 or send the form. Tell us the town and what needs work.
- 2
Property visit
We come out, look at the job and take the measurements we need.
- 3
Written quote
You get a written price for the work before anything starts.
- 4
Work completed
We do the work, test it and clean up the work area.
Does a garage without an opener change the layout?
Can a builder pick adjustable rails in some rooms and fixed shelves in others?
The garage door itself is giving trouble. Can that be handled too?
Can shelving go on a garage wall with a window?
Can a garage have a hanging rod for coats or work clothes?
Get a quote
Request Wire Shelving Installation in Alford
Send the address and the garage walls or rooms you want shelved, and the office will follow up.
