Paxton, Walton County
Garage Door Repair in Paxton, Florida
For garage doors that grind, scrape or rattle, and for doors with a broken spring.
A noisy garage door in Paxton
Big Bend Services, Inc. repairs garage doors in Paxton. A door that grinds, scrapes or rattles as it moves has a part that has worn, and the worn part is replaced. The same service covers broken springs, cables, tracks, panels, safety sensors, weather seals and openers.
Call (850) 819-6031, Monday to Friday, 7:00 AM to 4:00 PM, or fill in the form. You will get a written quote for the repair.
Match the sound
What the noise tells you
Listen while the door runs and note where the sound comes from.
Grinding along the sides
Rollers that are worn or have flat spots grind as they turn in the track.
Scraping
A roller has dropped out of the track, or a bent piece of track is rubbing the door edge.
Rattling or clunking at each section
Loose or cracked hinges between the sections let the panels knock as they bend over the curve.
Squeal at the top
Dry spring coils can squeal as the door opens.
The fix
Replacing rollers and hinges
Rollers
Each section has a roller on each side. When several are worn, a full new set lets the door run evenly.
Hinges
The hinges join one section to the next. Cracked or bent ones are replaced before they split.
End hinges
The hinges at the ends of each section also hold the rollers, so a worn roller and a cracked end hinge can be replaced together.
Track brackets
Loose brackets are tightened, and a bent run of track is straightened or replaced.
Extension springs
Noise on a door with extension springs
A door with extension springs has pulleys, and the lift cables run over them.
Where they sit
One at the back end of each horizontal track, and one on each spring.
The sound
A worn pulley squeals or chatters as the cable runs across it.
The repair
Worn pulleys are replaced.
A groan as the door starts up
At the top of the door, the top rollers ride in brackets that can be adjusted in and out. A top bracket set too tight presses the top section into the stop along the header, and the door groans or shudders as it starts to open. The bracket is reset so the top section clears the stop, and the door starts up smoothly.
Stop and call
When the noise comes with a change in how the door moves
A door that is only noisy can keep running while you book the repair. A door that does one of these should be left where it is:
It jerks or stalls partway
A roller is binding, or a track is bent enough to catch the door.
It rises unevenly or slams shut
The springs are no longer holding the weight evenly.
A section bows as it goes over the curve
A hinge has cracked through and the section is bending where it should pivot.
Springs
When the door has a broken spring
A spring that snaps makes one loud bang, and afterward the door will not lift or rises only a few inches. The spring holds the weight of the door, so a broken one is replaced.
Leave the opener off
The opener cannot lift the full weight, and running it strains the motor.
Door stuck open
Do not pull it down by hand. Call and say it is open.
Two springs
On a door with a pair, ask about replacing both together so the door stays balanced.
Crooked door
A door that hangs low on one side
When one side of the door sits lower than the other, look at the lift cables that run down each side to the bottom corners.
Frayed cable
Strands sticking out of the cable near the bottom bracket mean it is wearing through. It is replaced before it snaps.
Cable off the drum
A cable that has jumped off the drum at the top leaves that side hanging. It is wound back on, or replaced if it has kinked.
Opener noise
Noise from the opener instead of the door
If the door runs quietly by hand with the release cord pulled, the sound is coming from the opener.
Chain slapping the rail
A chain that has stretched slaps the rail as it runs. The chain tension is adjusted.
Grinding inside the motor
Worn gears inside the housing grind before they strip. The gear set or the opener is replaced.
A bang at the top or bottom of travel
The travel limits are off, and the opener is driving the door past its stop. The limits are reset.
Seals and sections
Weather seals and dented sections
Bottom seal
A torn or flattened rubber strip along the bottom of the door lets in leaves, dirt and water. The strip is replaced so the door meets the floor.
Side and top seals
Cracked stop seal along the jambs and header leaves a line of daylight. It is replaced on each side and across the top.
Dented section
A section bent enough to catch on the track is replaced where a matching section can be had.
Booking a Paxton repair
Our office in Wewahitchka takes Paxton bookings by phone and through the form on this page. Describe the sound and when you hear it: every time the door moves, only on the way up, or only near the top or the bottom. Say too whether the door is getting harder to lift, and whether the opener takes it all the way open and closed.
Moving in
New to the house
If you have just moved in, the Paxton town page covers storage, gutters and the garage door together.
Garage shelving
Shelving for the garage walls, laid out around the door and opener.
Gutters
Cleaning and repair for the gutters that came with the house.
Same county
Garage door repair in other Walton County towns
What to expect
How a Paxton repair is set up
- 1
Contact
Call (850) 819-6031 or send the form. Tell us the town and what needs work.
- 2
Property visit
We come out, look at the job and take the measurements we need.
- 3
Written quote
You get a written price for the work before anything starts.
- 4
Work completed
We do the work, test it and clean up the work area.
Do you install new garage doors too?
Do you also work on shop and business doors?
Why is my door louder in the morning than later in the day?
How loud should a garage door be?
Get a quote
Request Garage Door Repair in Paxton
Send the Paxton address and describe the sound the door makes.
