Mon-Fri, 7:00 AM-4:00 PMCall Big Bend Services(850) 819-6031

Altha, Calhoun County

Garage Door Repair in Altha, Florida

For openers that hum or click without moving the door, worn seals, and every other garage door repair.

Torsion springs on the steel shaft above a closed garage door

Garage door and opener repair in Altha

Big Bend Services, Inc. repairs garage doors and openers in Altha, ZIP 32421. When an opener hums or clicks and the door stays put, the part that stopped it is repaired, whether it is in the opener or in the door. We also replace worn weather seals, replace broken springs, and repair cables, rollers, hinges, tracks, panels and safety sensors.

Call (850) 819-6031, Monday to Friday, 7:00 AM to 4:00 PM, or send the form for a written quote.

Garage door opener and rail mounted on a garage ceiling

Opener runs, door stays

Why an opener hums or clicks and the door does not move

The sound tells you the opener has power.

  • The door is too heavy

    A broken spring leaves the opener trying to lift the whole door. It hums, strains and stops, and the spring is replaced.

  • The release has been pulled

    If someone pulled the red release cord, the opener runs but is not connected to the door.

  • A stripped drive gear

    Inside the motor housing, a drive gear turns the chain or belt. When its teeth wear off, the motor hums and nothing moves.

  • A click and nothing else

    A click with no hum and no movement can come from a fault inside the opener.

  • A binding door

    A door jammed in its track, or with a frozen roller, will not move even for a good opener. The door is repaired first.

White sectional garage door with a window row raised to show a clean garage

Opener repair

Repairing an opener or fitting a new one

  • One failed part

    A worn drive gear or a travel switch on an opener with a sound motor is an opener repair.

  • A failed motor

    When the motor itself has burned out, ask about a new opener.

  • A new door

    A new opener can go in with a new door, fitted at the same time.

Two-story home with a carriage-house style garage door

Controls

Remote or wall button not working

  • Remote only

    The remote has lost its pairing with the opener, or the remote itself has failed.

  • Wall button only

    The button or the thin wire from it to the opener has failed, and the button or wire is replaced.

  • Both controls fail

    When neither the remote nor the wall button moves the door, the fault is in the opener or its power supply.

White sectional garage door raised halfway on a single-story home

An opener that stops or reverses partway

Some openers move the door but stop short, or turn around halfway down. The opener has two settings that control this: how far the door travels, and how hard the opener pushes before it treats something as in the way. If either is off, the door stops early or reverses at the floor. Resetting them is an opener repair.

Single-story home with three white garage doors side by side

Weather seals

Gaps, drafts and debris under the door

A closed door should meet the floor and the frame with no daylight showing. When it does not, the seals are due.

  • Light or debris along the bottom

    The rubber seal on the bottom of the door has flattened, split or pulled out of its channel, and leaves, dirt and water come in under it. A new bottom seal is fitted.

  • Light down the sides or top

    The stop seal on the jambs and header has cracked or come loose. It is replaced along each side and across the top.

  • A bent or cracked retainer

    The channel that holds the bottom rubber can bend or crack, and a new rubber will not stay in it. The retainer is replaced along with the rubber.

Large metal building with a big overhead door and a walk-in door

Other repairs

The rest of the garage door

  • Cables

    A frayed or snapped lift cable is replaced.

  • Tracks, rollers and hinges

    A door off track is set back, and worn rollers and cracked hinges are replaced.

  • Safety sensors

    Sensors out of line are reset, and failed ones are replaced.

  • New doors

    New doors are measured to the opening.

Steel hinge and roller on a white garage door section

Booking an Altha repair

Our office in Wewahitchka takes Altha bookings by phone and through the form. If the house is a rental or you are not living there, give us the name and number of whoever can open the garage. Tell us what you hear when you press the button, whether the remote and the wall button behave the same, and whether the door moves by hand with the release pulled. If the opener has a light, say whether it comes on when you press the button.

Large white garage door with a row of window panels on a stucco building

At the same address

Other work at the same address

The Altha town page covers the other services, and they can go on the same request.

  • Laundry and garage shelving

    Wire shelving supplied and installed.

  • Gutters and downspouts

    Cleaning, repair and downspout changes.

Steel roll-up door in the brick wall of a commercial building
White garage door with a row of windows, partly open beside a palm tree

Same county

Garage door repair in other Calhoun County towns

Dark brown carriage-style garage door on a brick two-car garage

What to expect

How an Altha repair is booked and done

  1. 1

    Contact

    Call (850) 819-6031 or send the form. Tell us the town and what needs work.

  2. 2

    Property visit

    We come out, look at the job and take the measurements we need.

  3. 3

    Written quote

    You get a written price for the work before anything starts.

  4. 4

    Work completed

    We do the work, test it and clean up the work area.

Get a Quote

New garage door sections and track stacked inside a garage

FAQ

Altha garage door and opener questions

Have another question? Call (850) 819-6031.

How do I open the garage if the opener has failed?
Close the door first if you can. Then pull the red release cord hanging from the opener rail, and the door can be lifted and lowered by hand.
Can a new opener go on an old door?
Yes, as long as the door is balanced. With the release pulled, a balanced door stays put when you let go of it halfway up.
The bottom seal is new but there is still a gap at one end. Why?
A cable that has stretched lets one side sit high, and it is replaced and the door leveled.
Do side seals need replacing when the bottom seal does?
Not always. They wear at different rates.
Should the opener be unplugged while waiting for a repair?
If it is humming against a stuck door, unplugging it stops the motor from overheating. Plug it back in once the repair is done.
Why does the opener light flash when I press the button?
On some openers a flashing light is the signal for a sensor fault. The door will not close until the two sensors can see each other again.

Get a quote

Request Garage Door Repair in Altha

Send the Altha address and describe what the opener does when you press the button.

(850) 819-6031

511 S Highway 71, Wewahitchka, FL 32465
Monday to Friday, 7:00 AM to 4:00 PM

Stucco home with an almond raised-panel garage door

Your information is used to respond to this request. See our Privacy Policy.